Stihl TS 480i Notice D'emploi page 20

English
► Fit the support with the longer banjo bolt on
the adjusting lever (3) – screw in the banjo bolt
and tighten with the combination wrench
► Insert the water hose into the guide in the V-
belt guard (arrow) from the water connection
towards the guard – avoid tight radiuses
8.1.9 Checking the adjustment range of the
guard
► Rotate the guard forwards and backwards as
far as possible – adjustment range (A) must be
limited by the stop pin
Continue as described in the chapter "Tensioning
the V-belt".
8.2 Inboard mounting
► Disassemble the abrasive wheel (see "Fitting /
replacing an abrasive wheel")
► Remove the water attachment
► Remove the adjusting lever
► Slacken the V-belt
► Remove the V-belt guard
► Remove the "cast arm with guard"
20
8.2.1
► Remove screw (1) from the limit stop (2)
► Pull off the limit stop (2)
A
► Turn the "cast arm with guard" so that the
guard is on the inboard side
► Insert limit stop (2) – align the hole in the limit
stop with the hole in the cast arm
► Screw in the bolt (1) and tighten up
► Remove the nuts (3)
► Turn the guard so that it is in the position
shown (see picture)
► Screw in and tighten the stop pin (3)
► Install the adjusting lever
► Mount "cast arm with guard" – guard on the
inboard side
► Install the V-belt guard
► Connect water connection
8 Assembling the cast arm and guard
Preparing the "cast arm with guard" for
inboard mounting
1 2
3
1 2
3
0458-753-8221-D