Stihl TS 480i Notice D'emploi page 12

English
3.7 Cutting concrete pipe
A
The procedure is dependent on the outer diame‐
ter of the pipe and the maximum possible cutting
depth of the abrasive wheel (A).
► Secure pipe against vibrations, slipping and
rolling away
► Note weight, tension and direction of fall of the
part to be severed
► Determine and mark direction of cut
► Determine sequence of cuts
Outer diameter is smaller than the maximum cut‐
ting depth
► Make one cut from the top to the bottom
Outer diameter is greater than the maximum cut‐
ting depth
Plan first, then cut. Several cuts are needed –
correct sequence is important.
► Turn guard at rear stop
12
► Always start at the bottom, use the upper
quarter of the abrasive wheel for cutting
► Use the upper quarter of the abrasive wheel
for cutting the opposite lower side.
► First lateral cut on the top half of the pipe
► Second lateral cut in the marked area – never
cut into the area of the last cut, to ensure a
firm hold on the part of pipe to be cut
Only make the last top cut once all bottom and
lateral cuts have been made.
3 Sample Applications
0458-753-8221-D