Stihl TS 480i Notice D'emploi page 29

20 Cut-off Machine Cart
6
5
1
► Remove the V-belt from the front pulley
► Remove the nuts (1)
► Remove the starter cover (5)
► Do not remove the "cast arm and guard" (6) –
hold it in place on the studs until the starter
cover is fitted back in position
► Remove the defective V-belt
8
► Carefully insert the new V-belt (7) on the V-
belt pulley (8) on the engine and the front V-
belt pulley (9)
NOTICE
The belt action must run smoothly.
10
5
1
► Fit the starter cover (5) over the studs (10)
► Tighten up the nuts (1) by hand
0458-753-8221-D
1
1
9
7
10
10
1
1
► Push the V-belt guard (4) into place
► Screw in the bolt (3) and tighten up
► Insert the water hose into the guide in the V-
belt guard (arrows) from the water connection
towards the guard – avoid tight radiuses
Continue as described in the chapter "Tensioning
the V-belt".
20 Cut-off Machine Cart
The cut-off machine can be mounted on the
STIHL cut-off machine cart FW 20 (special
accessory) in a few easy steps.
The cut-off machine cart makes it easier to
– repair damaged roadways
– apply roadway markings
– cut expansion joints
21 Storing the Machine
If not used for periods of about 30 days or longer
English
4
3
29