Operation; Setup - Titan PowrLiner 850 Mode D'emploi

Description of unit
Relief Valve
The relief valve (fig. 5, item 1) directs material to the material
bleed hose when set to PRIME (
p
hose when set to SPRAY (
The arrows on the relief valve knob shows the rotation
k
directions for PRIME ( ) and SPRAY (
Shutoff Switch
The engine shutoff switch (fig. 5, item 2) will shut the engine
off when it is running.
Press and hold the shutuff switch in order to shut the engine
off.
DirectLink™
Spraying pressure is determined by the motor throttle.
The throttle is regulated by adjusting the DirectLink™ pressure
control knob (fig. 5, item 3). The higher the throttle, the higher
the spraying pressure.
AutoOiler™
The AutoOiler (fig. 5, item 4) is designed to provide lubrication
to the fluid section of the pump. After initial setup, press the
AutoOiler button 2-3 times before each use.
3
4
Sureflo™ Valve
The Sureflo™ Valve (fig. 6, item 1) is designed to keep the inlet
valve open and from sticking to dried materials.
The Sureflo Valve is activated manual by the user.
1
k
) or to high pressure spray
).
p
).
2
1
GB
4.

Operation

This equipment produces a fluid stream at
extremely high pressure. Read and understand
the warnings in the Safety Precautions section
at the front of this manual before operating
this equipment.
4.1

Setup

1. Attach the handle to the cart (fig. 7).
a. Line up the hole in the bottom of the handle with the
support weldment on the cart.
b. Thread the bolt through the hole in the handle and
the weldment. Tighten by turning the knob of the bolt
clockwise (1).
c. Position the handle at the desired height. Loosen the
knob on the rear of the support weldment (2) in order to to
loosen the handle.
d. Pull the handle up or down to the desired height. Tighten
the handle knob in order to secure the handle.
2
1
i
The spray gun and cables are mounted to the
gun support bar at the factory.
Do not attach the tip to the spray gun yet.
Remove the tip if it is already attached.
2. Make sure that the siphon tube and the bleed hose are
attached and secure.
3. Using a wrench, thread the airless spray hose to the
outlet fitting on the sprayer. Tighten securely.
4. Attach an airless spray gun to the spray hose. Using
two wrenches (one on the gun and one on the hose),
tighten securely.
5. Position the spray gun (fig 8).
a. Loosen the support bar knob (1) and slide the gun support
bar to the desired horizontal position. Make sure the gun is
far enough away from the cart so that the rear wheel does
not track over the fresh spray pattern.
b. Loosen the gun riser clamp (2) and slide the spray gun to
the desired vertical position. A distance of 6" from the tip to
the spray surface is a good starting point.
10
Operation
PowrLiner 850