Preparing To Paint - Titan PowrLiner 850 Mode D'emploi

2
1
The height of the spray gun affects the width
i
of the spray pattern (i.e., the lower the gun, the
smaller the line width). Tip size also affects line
width.
6. Make sure the gun cable is operating properly.
When pulling the spray lever on the cart handle, the
gun cable should be pulling the trigger. This cable is
factory-set to operate properly.
If adjustment to the gun trigger tension is required,
refer to the "Adjusting the Trigger Tension" procedure
in the Maintenance section of this manual.
7. Turn the relief valve knob to the PRIME (
Never operate unit for more than ten seconds
without fluid. Operating this unit without fluid
will cause unnecessary wear to the packings.
Attention
8. Remove AutoOiler cap with a flat blade screwdriver.
Squirt Piston Lube™ into the AutoOiler. Replace cap.
Push AutoOiler button 2-5 times to lubricate the fluid
section.
9. Check the engine oil level. The gasoline engine oil level
is determined by the manufacturer. Refer to the engine
manufacturer's service manual (supplied).
10. Fill the gas tank on the engine with unleaded gasoline
only. Do not mix the gasoline with 2-cycle oil.
PowrLiner 850
GB
4.2
Before painting, it is important to make sure that the fluid in
the system is compatible with the paint that is going to be
used.
i
i
Attention
1. Place the siphon tube into a container of the
k
) position.
2. Place the bleed hose into a metal waste container.
3. Turn the relief valve knob to the PRIME (
4. Fully depress the pusher stem to make sure the inlet
5. Turn the DirectLink pressure control knob fully
6. Start the engine (fig. 11):
a. Move the choke lever (1) up to the full choke position.
b. Push the rubber prime button (2) 7-10 times.
c. Pull the starter rope (3) rapidly and firmly. Continue to hold
d. Once the engine is running, slowly move the choke lever (1)
11

Preparing to paint

If this unit is new, it is shipped with test fluid in
the fluid section to prevent corrosion during
shipment and storage. This fluid must be
thoroughly cleaned out of the system with
mineral spirits before you begin spraying.
Incompatible fluids and paint may cause the
valves to become stuck closed, which would
require disassembly and cleaning of the
sprayer's fluid section.
Always keep the trigger lock on the spray gun
in the locked position while preparing the
system. If necessary, loosen the gun holder
clamp knob and then engage the spray gun
trigger lock.
appropriate solvent for the material being sprayed
(refer to recommendations of the material
manufacturer). An example of the appropriate solvent
is water for latex paint.
ball is free.
clockwise to minimum.
the rope as you let it return. Pull and return the rope until
the engine starts.
down to the closed position
1
2
3
Operation
k
) position.