Special Cleanup; Cleaning / Replacing The Gun Filter - Titan PowrLiner 850 Mode D'emploi

Cleanup
5.3

Special cleanup

Perform the following procedure after spraying
with water-based materials only.
Attention
Perform the following procedure when the valves of the
sprayer are stuck or when preparing the sprayer for long term
storage. The use of a pump cleaning adapter that attaches to
the bottom of the siphon tube is required (the pump cleaning
adapter is included with the sprayer).
1. Lock the gun and remove the spray tip assembly. If
necessary, loosen the gun holder clamp knob and then
engage the spray gun trigger lock. Move the spray gun
to its original position and tighten the clamp knob.
Place the suction tube and return hose into an empty
waste container.
2. Using a garden hose,
rinse off the siphon
tube (1), return
hose and inlet filter.
Empty the waste
container.
3. Remove the inlet
filter from the
suction tube and
place into a waste
container.
4. Verify that the seals
(2) are present inside
the adapter (3) and
siphon tube. Thread
the pump cleaning
adapter onto a
garden hose (4). Connect the hose and adapter to the
fitting on the end of the siphon tube.
5. Unclip the return hose from the siphon tube and place
it into the waste container.
6. Turn the relief valve knob to the PRIME (
7. Turn on the water supply.
8. Start the engine. Water will go into the siphon tube and
out through the return hose. Let the sprayer run for a
few minutes to allow the return hose to be flushed.
9. Turn off the sprayer by pressing and holding the engine
shutoff switch until the motor shuts off.
10. Place a metal waste container underneath the spray
gun to catch the cleaning solution.
11. Start the engine.
12. Turn the relief valve knob to the SPRAY (
13. Turn the DirectLink pressure control knob slowly
counterclockwise to increase the pressure.
14. Fully pull the spray lever on the cart handle to trigger
the spray gun. Fluid will begin flowing through the
spray hose and out of the gun.
15. Continue to pull the spray lever on the cart handle until
the material is flushed out of the hose and the water
coming out of the gun is clean.
16. Release the spray lever.
17. Follow the "Pressure Relief Procedure" found in the
Operation section of this manual.
3
k
) position.
p
) position.
GB
5.4

Cleaning / replacing the gun filter

The gun filter must be cleaned after every use of the sprayer.
When using thicker spray materials, the filter might need to be
cleaned more often.
1. Perform Pressure Relief Procedure in the Operation
section of this manual.
2. Unscrew the fitting (1) from the bottom of the spray
gun using an adjustable wrench, making sure not to
lose the spring (2).
3. Remove the filter (3) from the spray gun housing and
clean with the appropriate cleaning solution (warm,
soapy water for latex paints, mineral spirits for oil-based
materials).
4. Inspect the filter for holes (4). Replace if holes are
found.
1
2
4
Never poke the filter with a sharp instrument!
Attention
5. Replace the cleaned filter, tapered end first (5), into
the gun housing. The tapered end of the filter must be
loaded properly into the gun. Improper assembly will
result in a plugged tip or no flow from the gun.
6. Reassemble the spray gun.
16
5
3
4
2
1
PowrLiner 850