Publicité
Les langues disponibles
Les langues disponibles
3
3
Close the oven door
halfway to the first
opening position. Then
pull forward and remove
the door from its seat.
5
5
Release the locking
system to remove the
internal glass panel.
7
2
1
7
First lift carefully and
then remove the glass
panel.
Clean the glass panel with water and soap. Dry the
glass panel carefully.
When the cleaning is completed, install the glass panel
and the oven door. Do the above steps in the opposite
sequence.
Troubleshooting
Warning! Refer to Safety chapters.
4
4
Put the door on a soft
cloth on a stable surface.
6
90°
6
Turn the two fasteners by
90° and remove them
from their seats.
The screen-printing zone must face the inner side of the
door. Make sure that after the installation the surface of
the glass panel frame on the screen-printing zones is
not rough when you touch it.
Make sure that you install the internal glass panel in the
seats correctly.
Replacing the lamp
Put a cloth on the bottom of the interior of the appliance.
It prevents damage to the lamp glass cover and the
cavity.
Warning! Danger of electrocution!
Disconnect the fuse before you replace
the lamp.
The lamp and the lamp glass cover can
be hot.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box or deactivate
the circuit breaker.
The back lamp
1. Turn the lamp glass cover counterclockwise to
remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C heat-
resistant lamp.
4. Install the glass cover.
11
Publicité
