Publicité
Les langues disponibles
Les langues disponibles
EN
Troubleshooting Guide (Continued)
Problem
LED on receiver flashes
rapidly and aircraft will
not respond to transmit-
ter (after binding)
Control surface does
not move
Controls reversed
Motor loses power
Motor power quickly
decreases and in-
creases then motor
loses power
Servo locks or freezes
at full travel
Limited Warranty
What this Warranty Covers
Horizon Hobby, LLC, (Horizon) warrants to the
original purchaser that the product purchased (the
"Product") will be free from defects in materials and
workmanship at the date of purchase.
What is Not Covered
This warranty is not transferable and does
not cover (i) cosmetic damage, (ii) damage
due to acts of God, accident, misuse, abuse,
negligence, commercial use, or due to improper
use, installation, operation or maintenance, (iii)
modification of or to any part of the Product, (iv)
attempted service by anyone other than a Horizon
Hobby authorized service center, (v) Product not
purchased from an authorized Horizon dealer, or
(vi) Product not compliant with applicable technical
regulations, or (vii) use that violates any applicable
laws, rules, or regulations.
16
Possible Cause
Less than a 5-second wait between first
powering on transmitter and connecting
flight battery to aircraft
Aircraft bound to different model memory
(ModelMatch
radios only)
™
Flight battery/transmitter battery charge is
too low
Transmitter may have been bound to a
different model (or with a different DSM
Protocol)
Aircraft or transmitter is too close to large
metal object, wireless source or another
transmitter
Control surface, control horn, linkage or
servo damage
Wire damaged or connections loose
Flight battery charge is low
Control linkage does not move freely
Transmitter settings reversed
Damage to motor or power components
Battery power is down to the point of
receiver/ESC Low Voltage Cutoff (LVC)
Travel adjust value is set above 100%,
overdriving the servo
Leaving transmitter on, disconnect and
reconnect flight battery to aircraft
Select correct model memory on transmitter
and disconnect and reconnect flight battery
to aircraft
Replace/recharge batteries
Select the right transmitter or bind to the
new one
Move aircraft and transmitter to another
location and attempt linking again
Replace or repair damaged parts and adjust
controls
Do a check of wires and connections, con-
nect or replace as needed
Fully recharge flight battery
Make sure control linkage moves freely
Adjust controls on transmitter appropriately
Do a check of motor and power components
for damage (replace as needed)
Recharge flight battery or replace battery that
is no longer performing
Set Travel adjust to 100% or less and/or set
sub-trims to Zero and adjust linkages
mechanically
OTHER THAN THE EXPRESS WARRANTY ABOVE,
HORIZON MAKES NO OTHER WARRANTY OR
REPRESENTATION, AND HEREBY DISCLAIMS ANY
AND ALL IMPLIED WARRANTIES, INCLUDING,
WITHOUT LIMITATION, THE IMPLIED WARRANTIES
OF NON-INFRINGEMENT, MERCHANTABILITY
AND FITNESS FOR A PARTICULAR PURPOSE. THE
PURCHASER ACKNOWLEDGES THAT THEY ALONE
HAVE DETERMINED THAT THE PRODUCT WILL
SUITABLY MEET THE REQUIREMENTS OF THE
PURCHASER'S INTENDED USE.
Purchaser's Remedy
Horizon's sole obligation and purchaser's sole and
exclusive remedy shall be that Horizon will, at its
option, either (i) service, or (ii) replace, any Product
determined by Horizon to be defective.
Solution
Publicité
