Toro TimeCutter MX 4275T Manuel De L'utilisateur page 50

Leveling from Side to Side
1. Move to the left side of the machine.
2. Set the anti-scalp rollers to the top holes or
remove them completely for this procedure; refer
to Adjusting the Anti-Scalp Rollers (page
3. Set the height-of-cut lever to the 76 mm (3 inch)
position; refer to
(page 24).
4. Place 2 blocks, each having a thickness of 6.6
cm (2-5/8 inches), under each side of the front
edge of the deck but not under the anti-scalp
roller brackets (Figure 71
5. Place 2 blocks, each having a thickness of 7.3
cm (2-7/8 inches), under the rear edge of the
cutting deck skirt, 1 on each side of the cutting
deck (Figure 71 or
Figure 71
Mower Decks with 2 Blades
1. Wood block—6.6 cm
(2-5/8 inches) thick
Adjusting the Height of Cut
or Figure 72).
Figure 72).
2. Wood block—7.3 cm
(2-7/8 inches) thick
25).
1. Wood block—6.6 cm
(2-5/8 inches) thick
6. Remove the hairpin cotter and washer from the
lower lift-arm pin
g298027
1. Height-of-cut plate
2. Hairpin cotter
7. Rotate the height-of-cut plate to a different hole
so that it supports the weight of the mower deck
after you install the plate
48
Figure 72
Mower Decks with 3 Blades
2. Wood block—7.3 cm
(2-7/8 inches) thick
(Figure 73).
Figure 73
3. Washer
(Figure
g298028
g294197
74).