Toro TimeCutter MX 4275T Manuel De L'utilisateur page 49

Figure 67
Mower Decks with 2 Blades
1. Blades side to side
2. Outside cutting edges
Figure 68
Mower Decks with 3 Blades
1. Blades side to side
2. Outside cutting edges
Checking the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install
the mower. If the front of the mower is more than
7.9 mm (5/16 inch) lower than the rear of the mower,
adjust the blade level.
1. Park the machine on a level surface, disengage
the blade-control switch (PTO), and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
g294044
3. Measure from the tip of the
blade to the flat surface
here.
g296913
3. Measure from the tip of the
blade to the flat surface
here.
ARK
3. Set the height of cut to 76 mm (3 inches).
4. Carefully rotate the blades so they are facing
front to rear (Figure
5. Measure from the tip of the front blade to the flat
surface and the tip of the rear blade to the flat
surface (Figure 69
Note:
If the front blade tip is not 1.6 to 7.9 mm
(1/16 to 5/16 inch) lower than the rear blade
tip, continue to the
Blade Slope (page 49)
Mower Decks with 2 Blades
1. Blades front to rear
2. Outside cutting edges
Mower Decks with 3 Blades
1. Blades front to rear
2. Outside cutting edges
47
69).
or Figure 70).
Adjusting the Front-to-Rear
procedure.
Figure 69
3. Measure from the tip of the
blade to the flat surface
here.
Figure 70
3. Measure from the tip of the
blade to the flat surface
here.
g294046
g296914