Toro TimeCutter MX 4275T Manuel De L'utilisateur page 37

Checking the Engine-Oil Level
Service Interval: Before each use or daily
Note:
Check the oil when the engine is cold.
Important:
If you overfill or underfill the engine
crankcase with oil and run the engine, you may
damage the engine.
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
Note:
Ensure that the engine is cool so that the
oil has had time to drain into the sump.
3. To keep dirt, grass clippings, etc., out of the
engine, clean the area around the oil-fill cap and
dipstick before removing it
Figure 41
ARK
(Figure 41).
g365791
35
Changing the Engine Oil and Oil
Filter
Service Interval: Every 100 hours or yearly,
whichever comes first—Change the
engine oil and oil filter (more often
in dirty or dusty conditions).
1. Park the machine on a level surface to ensure
that the oil drains completely.
2. Disengage the blade-control switch, and move
the motion-control levers outward to the P
position.
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4. Drain the oil from the engine
Figure 42
5. Change the engine-oil filter
Note:
Ensure that the oil-filter gasket touches
the engine and then turn the filter an extra 3/4
turn.
ARK
(Figure 42).
g225280
(Figure 43).