Toro TimeCutter MX 4275T Manuel De L'utilisateur page 19

Machines with 127 cm (50-inch)
Mower Decks
1. Park the machine on a level surface, disengage
the blade-control switch, and move the
motion-control levers outward to the P
position.
2. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the mower deck; refer to
Mower Deck (page
4. Remove the 3 locknuts (5/16 inch) from the
welded posts of the right baffle
Figure 13
1. Locknut—5/16 inch (4)
2. Right baffle
5. Remove the 2 carriage bolts and 2 locknuts
securing the right baffle to the deck and remove
the baffle (Figure
6. Locate the 3 bolts in loose parts and use the
existing locknuts and install these fasteners into
the holes used for the welded posts
to prevent flying debris.
Note:
Install the bolt upward, through the
underside of the deck and use an existing
locknut to secure from the topside.
ARK
Removing the
49).
(Figure 13).
3. Carriage bolt—5/16 x 3/4
inch
4. Welded post (3)
13).
(Figure
7. Remove the 2 locknuts (5/16 inch) from the
welded posts of the left baffle
1. Locknut—5/16 inch (3)
2. Left baffle
8. Remove the carriage bolt and locknut securing
the left baffle to the deck and remove the baffle
(Figure 14).
9. Locate the 2 bolts in loose parts and use the
existing locknuts and install these fasteners into
the holes shown in
to prevent flying debris.
Note:
Install the bolt upward, through the
g297022
underside of the deck and use an existing
locknut to secure from the topside.
10. Remove the nut from the grass deflector rod
under the mower deck
13)
17
(Figure 14).
Figure 14
3. Welded post (2)
4. Carriage bolt—5/16 x 3/4
inch
Figure 14 on the mower deck
(Figure 15).
g297021