Toro TimeCutter MX 4275T Manuel De L'utilisateur page 45

Figure 56
1. Wire form
2. Nut
7. Using a spring-removal tool (Toro Part No.
92-5771), remove the idler spring from the deck
hook to remove tension on the idler pulley, and
roll the belt off the pulleys
58).
WARNING
The spring is under tension when
installed and can cause personal injury.
Be careful when removing the belt.
Figure 57
Mower decks with 2 blades
1. Idler pulley
2. Mower belt
3. Outside pulley
g336421
3. Idler pulley
(Figure 57 or Figure
g298025
4. Spring
5. Engine pulley
6. Spring-removal tool
Mower decks with 3 blades
1. Idler pulley
2. Mower belt
3. Outside pulley
8. Route the new belt around the engine pulley and
mower pulleys
9. Using a spring-removal tool (Toro Part No.
92-5771), install the idler spring over the deck
hook and place tension on the idler pulley and
the mower belt
10. For decks with 3 blades, tighten the nut securing
the wireform to the idler pulley .
Note:
Position the wireform against the idler
arm as shown in
11. Install the pulley covers.
12. Tighten the bottom 2 bolts for the mower-deck
curtain to the mower deck. Refer to
the Mower-Deck Curtain (page
43
Figure 58
4. Spring
5. Engine pulley
6. Spring-removal tool
(Figure 57 or Figure 58).
(Figure 57 or Figure 58).
Figure 56.
Releasing
32).
g298026