Arktic 233900 v.02 Manuel De L'utilisateur page 9

paint, aerosol cans with a flammable propellant, flammable
or explosive substances, etc. inside or near the appliance.
• Once installed, the appliance must not be tilted at an angle
greater than 5° and it is necessary to wait 2h before connect-
ing it to the power supply to switch it on. The same applies if
the appliance is moved afterwards.
• If the appliance has been switched off or disconnected from
the power supply, it is necessary to wait 5 minutes until
switching on again.
• No other appliances should be plugged into the same socket
as with this appliance.
• Do not attempt to climb onto the appliance.
Intended use
• This appliance is intended to be used for commercial appli-
cations, for example in kitchens of restaurants, canteens,
hospitals and in commercial enterprises such as bakeries,
butcheries, etc., but not for continuous mass production of
food.
• The appliance is designed for keep beer, including beverages,
under cool state and to display them for retail sale in restau-
rants, canteens, other commercial enterprises such as bak-
eries, butcheries, supermarkets, etc. Any other use may lead
to damage of the appliance or personal injury.
• Operating the appliance for any other purpose shall be
deemed a misuse of the device. The user shall be solely liable
for improper use of the device.
Grounding installation
This appliance is classified as protection class I and must be
connected to a protective ground. Grounding reduces the risk
of electric shock by providing an escape wire for the electric
current.
This appliance is fitted with a power cord with grounding plug
or electrical connections with grounding wire. The connections
must be properly installed and grounded.
Main parts of the product
(Fig.1 on page 3)
1. Digital control panel
2. Main switch
3. Light ON/OFF switch
4. Air vents
5. Door key lock
6. Shelf
7. Handle
8. Light
Remark: The content of this manual applies for all listed items
unless specified otherwise. The appearance may vary from the
shown illustrations.
Control panel
(Fig.2 on page 3)
9. Display panel
10. Indicator light status
11. Set button
- Enter the status of parameter setting
- Switch between menu and parameter
12. Rst button
- Exit from parameter setting status
- Exit from one-key recovery status
- Force to start defrost
13. Up
- Adjust menu and parameter
14. Down
- Adjust menu and parameter
- Press 10s to execute parameter one-key recovery
Indicator light status description
Symbol
Status Description
indicator
ON Under setting mode
OFF Operating under the setting condition
ON Compressor works and cooling active
Compressor not works and cooling
OFF
inactive
FLASH Preparing cooling process
ON Under refrigeration process
C
ON Under defrost process
def
ON Under heating process
H
Circuit diagram
(Fig.3 on page 4)
233900 v.02, 226568 v.02:
A1. Power Switch
B1. Power regulator
C1. LED light bar (Max 3W)
D1. Fan
E1. Temperature Controller
F1. Power regulator
G1. Fan
H1. Capacitor
I1. Starter
J1. Compressor
K1. Overload Protector
235829 v.02:
A2. Power Switch
B2. Power regulator
C2. LED light bar (Max 5W)
D2. Fan
E2. Temperature Controller
F2. Fan
G2. Capacitor
H2. Starter
I2. Compressor
J2. Overload Protector
GB
9