krispol STARCUS F50 Manuel D'installation page 78

SETTINGS OF FUNCTION PARAMETERS IN MENU
9. —
MENU 9
9.-
Door drive rotating
direction setting
ERROR CODES
Error
Description
Code
E 0.
Encoder failure, the
encoder cannot write and
read data.
E 1.
No motor motion signal is
Detected.
E 2.
The positive and negative
poles of the motor wire
are reversed.
E 3.
Motor current is too high.
78
Door drive rotating direction setting (UP/DOWN)
9.-
9.1
9.0
Note
Press and hold the SET button for about 6 se-
conds until the display shows 0.; then release the
button - use the + button to select 9.;then press
the SET button shortly to select this function.
The display shows.
9.1
Rotating direction (by default).
9.0
Reverse rotation / Downward direction
of rotation.
After adjusting the rotating direction of the
door drive, it is necessary to relearn the travel
limit.
Measures
1. Replace the encoder.
2. Replace the encoder cable.
1. Check whether the wiring between the limiter and
the control board is loose.
1. Exchange the positive and negative poles
of the motor.
1. Choose matching control system and motor.
2. Check the door body.
3. Replace the high-power door drive.