krispol STARCUS F50 Manuel D'installation page 61

SETTINGS OF FUNCTION PARAMETERS IN MENU
2. 1
Speed control opening
2. 1 Press and hold the SET button for about 6 seconds
until the display shows 0.-; then release the button
- use the + button to select 2.-; then shortly press
the SET button to select this parameter.
- the display shows 2.1
- then briefly press the SET button to select this
parameter.
High speed, 100% of standard door opening
. 1
speed, 50% of soft closing speed.
High speed, 90% of standard door opening
. 2
speed, 40% of soft closing speed.
Medium speed, 80% of standard door opening
. 3
speed, 50% of soft closing speed.
Low speed, 70% of standard door opening
. 4
speed, 40% of soft closing speed.
Note: After the quick programming of the drive with
the "AAS" function (auto-adaptation system),
the opening speed is automatically selected
and optimized for the given door. If you
change this speed, re-program the door
limit positions !!!
61