krispol STARCUS F50 Manuel D'installation page 57

SETTINGS OF FUNCTION PARAMETERS IN MENU
1. —
MENU 1 Adjustment of travel limit position
1. 0
Operating mode selection
1. — Press and hold the SET button for about 6 se-
conds until the display shows 0.-; then release
the button.
Use the + button to select 1.- then shortly press
the SET button to select this parameter.
1. 0 - 1.0 appears on the display
- shortly press the SET button to select this
parameter.
Description of how this mode works. To open,
. 1
keep the button pressed. Closing requires hol-
ding down the button.
. 2 Description of how this mode works Opening
requires a short press of the button. Closing
requires holding down the button
- necessary if you purchased the "TOTMANN"
/ DEADMAN" version.
. 3 Description of how this mode works. To open,
keep the button pressed. Closing requires a
short button impulse.
Description of how this mode works (default).
. 4
Opening requires a short button impulse. Clo-
sing requires a short button impulse.
Note When the emergency stop function is active
with parameter set to
DOWN buttons work.
Press and hold the SET button for about
1. —
6 seconds until the display shows 0.-; then
release the button.
Use the + button to select 1.-; then shortly press
the SET button to select this parameter.
- 1.0 appears on the display.
. 1
the UP and
57