krispol STARCUS F50 Manuel D'installation page 62

SETTINGS OF FUNCTION PARAMETERS IN MENU
2. 2
Distance to start
deceleration for
closing
62
2.2 Press and hold the SET button for about 6 seconds
until the display shows 0.- then release the button
- use the + button to select 2. then shortly
press the SET button to select this parameter
- the display shows 2.2
- then briefly press the SET button to select
this parameter.
. 1 Deceleration distance before fully closing
for tracks:
SL- 10 [cm], HL-20 [cm], VL-25 [cm].
. 2 Deceleration distance before fully closing
for tracks:
SL- 20 [cm], HL-30 [cm], VL-40 [cm].
. 3 Deceleration distance before fully closing for
tracks:
SL- 25 [cm], HL-45 [cm], VL-50 [cm].
. 4 Deceleration distance before fully closing
for tracks:
SL- 40 [cm], HL-55 [cm], VL-60 [cm].
Note: The given values are approximate and may
vary depending on the size of the cable drums
used.
After the quick programming of the drive by
using the "AAS" function (self-adaptation
system), the distance of the door deceleration
activation is automatically selected and optimi-
zed for the given door. If you change this
setting, you must re-program the door travel
limit settings!!!