krispol STARCUS F50 Manuel D'installation page 56

SETTINGS OF FUNCTION PARAMETERS IN MENU
O. —
MENU 0 Travel limit settings
56
Press and hold the SET button for about 6 se-
O. —
conds until the display shows 0.-, then release
the button.
Press the SET button to enter the settings of
this function.
Then you can set the top travel limit position.
Use the + (up) and - (down) buttons to set the
door to the open position. Then briefly press the
SET button to save the top position.
Then the digital display will show
to start programming the bottom door (fully
closed).
Use the + (up) and - (down) buttons to set the
door to the closed position. Then briefly press
the SET button to save the bottom position.
Then the drive will start opening and closing the
door one by one to remember these settings.
If during the opening and closing cycle the error
E O
E O , will be displayed, check the cable connec-
tions to the encoder. If the connection is correct,
try to set the travel limit positions again.
will appear on the display.