Optional Battery Charger - Invacare Birdie EVO Manuel D'utilisation

CBJ1 and CBJ2 with LCD
Battery Battery
Indicator State
Type
Full
Charge
(100%)
Partial
Charge
(75%)
Partial
Charge
(50%)
Low
Charge
(25%)
Low
Charge
(0%)

5.9.3 Optional battery charger

(for control units with detachable battery only)
The procedure of removing or installing the battery
is the same for the control unit and the charger.
Removing the battery
1650023-B
Description
The battery is OK — no need
for charging (100%).
The battery is OK — no need
for charging (75%).
The battery needs to be
charged (50%).
The battery needs to be
charged (25%). Acoustic signal
when a button is pressed.
The battery needs to be
charged.
Some of the functionality of
the lift is lost and it is only
possible to lower the boom.
1.
A
B
1. Lift up on the handle A on the back of the battery B.
2. Lift the battery up and out away from the control unit
or charger .
Installing the battery
CAUTION!
Installing the battery improperly may cause injury
or damage.
– Make sure there is an audible click when
installing the battery on the control unit or
charger to confirm proper installation.
1. Place the battery B
on the control unit or
charger as shown and
make sure there is an
audible click.
When the battery is placed on the charger, the charge
LED will illuminate. When charging is complete,
charge LED will switch off.
A battery needing to be fully recharged will take
approximately four hours.
Usage
2.
15