Assembling The Mast To The Base; Unfolding The Spreader Bar; Installing The Actuator To The Boom; Installing The Lever For Manual Leg Spreader - Invacare Birdie EVO Manuel D'utilisation

Invacare® Birdie® EVO
1. Lock both rear castors B. Remove the locking pin A.
2. Raise the mast assembly C to an upright position by
stepping with one foot on the leg D and pulling the push
bar E upwards until the safety catch F snaps in place.
3.
Reinstall the locking pin A through the mast G and
base H. Ensure that the locking pin is correctly inserted.

4.3.2 Assembling the mast to the base

(fixed mast only)
1.
Lock both rear castors B and rotate the hand screws
anti-clockwise A to remove them from the base
2.
With the boom pointing in forward direction, lower the
mast C into the support of base D and reinstall the
hand screws A to fix the mast C to the base.
10

4.4 Unfolding the spreader bar

1.
1. Push and hold the boom A towards the mast B and
fold down the spreader bar clip C.
2. Fold down the spreader bar D and fold the spreader
bar clip C up until it clips to the actuator mounting
bracket E.

4.5 Installing the actuator to the boom

1. Release the clip and remove the quick release pin A
from actuator B.
2. Remove the actuator B from the bracket on the mast
and fit it together with the squeeze protection C to the
boom mounting bracket D.
3.
Align the holes and reinstall the quick release pin A and
secure it with the clip facing forwards.
Make sure that the quick release pin is completely
inserted and fixed with the clip facing forward, as
shown in figure 3.
4.6 Installing the lever for manual leg
spreader
1x 13 mm wrench
2.
1650023-B