After removing the two screws from the front fuselage con-
nection (1), also remove the two lateral chasses retention
screws (2).
Last, pull the landing skid frame (3) from the holder down-
wards.
The two fuselage halves can not be pushed apart far enough
at the front for the mechanics to be removed towards the
front,
Assembly of the mechanics is performed in reverse order.
Practical advice:
Use a piece of thin wire or a pin to align the holes in the
Figure 21
fuselage and the screw holes precisely on top of each other.
This makes it easer to turn on the screws.
56