Reely SKY XL 20 91 06 Notice D'emploi page 53

If the helicopter wants to drift forwards (see figure 17), reduce the speed and slide the trim slider for the roll function
(see figure 1, item 2) gradually to the back.
If you dismantled the Nick/Pitch stick function at your transmitter, then you must adjust the opposite steering trim (see
figure 1, item 12). Push the pitch lever carefully forward and check if the adjustment was sufficient. Repeat the proce-
dure until the model does not show any tendency to drift forward. If the helicopter wants to drift backward, carry out a
trim adjustment forward.
The trim slider for the pitch function always has to be in the bottom position for the drive motors to be
cleared.
If the control paths of the nod and roll trim slider are not quite adequate for an optimum correction, you have the
possibility to change the control of the lower rotor blades mechanically. For further information, refer to the chapter
"Fine-tuning the model helicopter".
Figure 17
53