Reely SKY XL 20 91 06 Notice D'emploi page 50

After successful conversion and adjustment of the retention
force, you have to detach the two connection cables (1) of
the control potentiometers by soldering them off and solder
them on again in reverse order.
In any case, observe the correct connection sequence of
the coloured wires.
Then insert the circuit board with the trainer socket and screw
on the back wall. Finally, perform a function control of the
entire system.
Figure 14
If you want different function assignments for the control stick than the default factory settings but are not in a position
to carry this out yourself, you can send the transmitter in to our customer service department in Hirschau.
Our technicians will convert the remote control to suit your requirements and you will be billed for this work.
50