Würth MIG 180-5S Mode D'emploi Original page 36

c. Lift the welding torch to the normal position to initi-
ate the arc and start welding.
(see fig. S on page 10)
Service, Maintenance,
Transportation and Storage
The welder needs regular maintenance as following:
Periodically clean dust, dirt, grease, etc. from your
welder. Every six months, or when necessary, remove
the welder cover panel and air-blow any dust and
dirt that may have accumulated inside the welder.
Replace power cord, ground cable, ground clamp,
or electrode assembly when damaged or worn.
MINOR AND ROUTINE MAINTENANCE
Store in a clean dry facility, free from corro-
sive gas, excess dust and high humidity. Temperature
range should be -12°C to +50°C and the relative
humidity not more than 90%.
When transporting or storing the welder after use,
it is recommended to repack the product as it was
received in order to protect it. (Cleaning is required
before storage and you need to seal the plastic bag
in the cardboard box before storage).
Guarantee
For this Würth power tool, we provide a guarantee
in accordance with the legal/country-specific regu-
lations from the date of purchase (verified by invoice
or delivery document). Damage that has occurred
will be corrected by replacement or repair.
Damage caused by normal wear, overloading or
improper handling is excluded from the guarantee.
Claims can only be accepted if the power tool is
sent undisassembled to a Würth branch office, your
Würth sales representative or a customer service
agent for Würth power tools.
Disposal
The machine, accessories and packaging
should be sorted for environmental-friendly
recycling.
Do not dispose of power tools
into household waste!
Only for EC countries:
According to the European Guideline 2012/19/EU,
power tools that are no longer usable, and accord-
ing to the European Guideline 2006/66/EC,
36
defective or used battery packs/batteries, must be
collected separately and disposed of in an environ-
mentally correct manner.
EC Declaration of Conformity
We declare under our sole responsibility that this
product is in conformity with the following standards
and standardization documents:
EN 60974- 1:2012, EN 60974-10:2014 in accord-
ance with the directives: 2014/35/EU, 2014/30/EU.
Technical documentation from:
A. Würth GmbH & Co. KG
Reinhold-Würth-Strasse 12-17
74653 Künzelsau
Germany
Würth International AG
Aspermontstrasse 1
CH-7004 Chur
SWITZERLAND
Gerd Rössler
Managing Director
Chur, dated:
Rico Januth
Product Manager Power
Tools