Black & Decker BDSG500 Traduction Des Instructions Initiales page 5

d. Remove any adjusting key or wrench
before turning the power tool on. A
wrench or a key left attached to a
rotating part of the power tool may
result in personal injury.
e. Do not overreach. Keep proper footing
and balance at all times. This enables
better control of the power tool in
unexpected situations.
f. Dress properly. Do not wear loose
clothing or jewellery. Keep your hair,
clothing and gloves away from moving
parts. Loose clothes, jewellery or long
hair can be caught in moving parts.
g. If devices are provided for the
connection of dust extraction and
collection facilities, ensure these are
connected and properly used. Use of
these devices can reduce dust related
hazards.
4. Power Tool Use and Care
a. Do not force the power tool. Use the
correct power tool for your application.
The correct power tool will do the job
better and safer at the rate for which it
was designed.
b. Do not use the power tool if the switch
does not turn it on and o . Any power
tool that cannot be controlled with the
switch is dangerous and must be
repaired.
c. Disconnect the plug from the power
source and/or the battery pack from the
power tool before making any
adjustments, changing accessories, or
storing power tools. Such preventive
safety measures reduce the risk of
starting the power tool accidentally.
d. Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands
of untrained users.
e. Maintain power tools. Check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may a ect the power
tools operation. If damaged, have the
power tool repaired before use. Many
accidents are caused by poorly
(Original instructions)
maintained power tools.
f. Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
g. Use the power tool, accessories and tool
bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed. Use of the power tool for
operations di erent from those intended
could result in a hazardous situation.
5. Service
a. Have your power tool serviced by a
qualifi ed repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.
6. Electrical safety
Your tool is double insulated;
therefore no earth wire is required.
Always check that the main voltage
corresponds to the voltage on the
rating plate.
Warning! If the power cord is
damaged, it must be replaced by the
manufacturer, authorized
BLACK+DECKER Service Center or an
equally qualifi ed person in order to avoid
damage or injury. If the power cord is
replaced by an equally qualifi ed person, but
not authorized by BLACK+DECKER, the
warranty will not be valid.
7. Labels on tool
The label on your tool may include the
following symbols:
Read Hz .......
Instructions
W .......
Manual
min .....
Use Eye
Protection
Use Ear
Protection
V ........ Volts
A ........ Amperes
ENGLISH
......
Hertz
Watts
......
minutes
......
..... Alternating
Current
.../min..
..... Direct
Current
n ....... No-Load
0
Speed
Class II
Construction
Earthing
Terminal
Safety
Alert Symbol
Revolutions
or Recipro-
cation per
minute
5