Mount Attachment Component; Mount Accessories - Festo ERMO Notice D'utilisation

ERMO
5.1.2

Mount attachment component

• Fasten the attachment component to the rotary table with
screws and centring sleeves. Observe maximum screw-in depth
and tightening torque (è Tab. 2).
Size
Screw
Max. screw-in depth
Tightening torque
Centring
Screw drill hole
Central drill hole
Tab. 2
5.1.3

Mount accessories

For use of the proximity sensors as reference switches:
Select proximity sensors corresponding to the input logic of the
used controller (PNP/NPN) (è www.festo.com/catalogue).
• Mount proximity sensors:
1. Loosen threaded pin 1 of the clamping component and remove
both.
2. Turn rotary table slowly until the marking 3 has reached the
position below the drill hole of the threaded pin 1.
As a result, the screw head for the switch contact in the
threaded hole is visible.
3. Screw the proximity sensor 2 into the thread up to the stop on
the screw head.
4. Unscrew the proximity sensor approx. 1.5 turns.
This results in a distance of 1.5 mm to the screw head of the
switch contact.
5. Tighten threaded pin in the clamping component (ß 2.5 mm).
Tightening torque:
– ERMO-12: 0.2 Nm,
– ERMO-16/25/32: 0.8 Nm.
22
12
M3
[mm] 7
[Nm] 1
@5H7
[mm]
@12H8
[mm]
Fig. 3
16 25
M4 M5
8 8.5
3 5
@7H7
@12H8 @15H8
Fig. 4
Festo – ERMO – 1505NH English
32
M5
10
5
@20H8
1
2
3