Safety; Intended Use; General Safety Information; Mounting And Connecting - Festo ERMO Notice D'utilisation

ERMO
2

Safety

2.1

Intended use

The ERMO rotary drive in combination with the controllers CMMO-ST or CMMS-ST is intended for swivel­
ling payloads (permissible controller è www.festo.com/catalogue). The product is intended for use in
industrial environments. Measures for interference suppression may need to be implemented in resid­
ential areas.
2.2

General safety information

• Take into consideration the legal regulations applicable for the location.
• Only use the product if it is in its original status and in an excellent technical status.
• Use the product only within the defined values (è 12 Technical data and 13 Characteristic curves).
• Take into account the labelling on the product.
• Do not make any unauthorised modifications to the product.
• Observe other applicable documents.
• Take into consideration the ambient conditions at the location of use.
• Protect the product during storage and operation from damaging influences. These influences in­
clude:
– Wetness or moisture
– Corrosive coolant or other materials (e.g. ozone)
– UV radiation
– Oils, greases and grease-solvent vapours
– Grinding dust
– Glowing chips or sparks
2.3

Mounting and connecting

• Observe tightening torques. Unless otherwise specified, the tolerance is ± 20 %.
2.4

Qualification of specialized personnel

Only qualified personnel may perform installation, commissioning, maintenance and disassembly of the
drive. The qualified personnel must be familiar with installation and operation of electrical control sys­
tems.
3

Function

The rotation of the motor is transferred over a helical gear unit to the rotary table. The reference posi­
tion of the rotary table can be detected with the help of accessories (è 5.1.3 Mount accessories).
Festo – ERMO – 1505NH English 19