Description Of Connections; Typical Installation - Roger Technology H70/200AC Instructions Et Consignes Pour L'installateur

6

Description of connections

Figures 1-2-3-4 show connection diagrams.
6.1

Typical installation

1
8
9
5
It is the installer's responsibility to verify the adequacy of the cables in
relation to the devices used in the installation and their technical
characteristics.
1 Power supply
2 Motor 1
3 Motor 2
4 Photocell - Receiver F2ES/F2S
5 Photocell - Transmitter F2ES/F2S
Key selector R85/60
Keypad H85/TTD - H85/TDS
(connecting to H85/DEC - H85/DEC2)
6
H85/DEC - H85/DEC2
(connecting to control unit)
LED Flashing light R92/LED230-FIFTHY/230
Power supply 230V~ (40 W max)
7
Antenna
8 Gate open indicator
Power supply 24 V~ (2 W max)
9 Courtesy light
Power supply 230 V~ (100 W max)
Encoder connection (if present)
SUGGESTIONS: with existing installations, we recommend checking the cross section of the cables and that
the cables themselves are in good condition.
52
7
6
4
2
Recommended cable
H07RN-F 3x1,5 mm
insulated cable (max 15 m)
Cable 4x1,5 mm
Cable 4x1,5 mm
Cable 4x0,5 mm
Cable 2x0,5 mm
Cable 3x0,5 mm
Cable 2x0,5 mm
Cable 4x0,5 mm
The number of conductors increases when using more than
one output contact on H85/DEC - H85/DEC2
Cable 2x1 mm
Cable tipo RG58 (max 10 m)
Cable 2x0,5 mm
Cable 2x1 mm
Cable 3x0,5 mm
3
4
double H07RN-F 3x2,5 mm
2
insulated cable (max 30 m)
(max 20 m)
2
(max 20 m)
2
(max 20 m)
2
(max 20 m)
2
(max 20 m)
2
(max 30 m)
2
(max 20 m)
2
(max 10 m)
2
(max 20 m)
2
(max 20 m)
2
(max 30 m)
2
5
double
2