I-Tech T-ONE EVO I Mode D'emploi page 36

Preliminary instructions.
Before using T-ONE clean the skin of the area to be treated; with the cable disconnected from
T-ONE, connect the electrostimulation cable jacks to the self-adhesive electrodes; position the
self-adhesive electrodes on the skin (see photos of electrode positions); connect the impulse
transmission cables to the relative jacks, then turn T-ONE on.
Warning: make sure that T-ONE is switched off before disconnecting the electrodes at the
end of the treatment.
Operating instructions (N.B. read the whole manual before using the equipment)
1. Turn T-ONE on using the
2. Select the program group (Sport, Beauty, Tens) using the button
3. Select the program using the
Sport programs display
4. Select male or female with
5. Select the muscle group with
Arms male
6. press to start program; the display shows connect cables and electrodes and
increase intensity of the used channels; to start intensity press
ONE will begin the session.
7. press the button for each use channel to increase current intensity until the personal
tolerance level is reached.
IACER SRL
button
buttons .
Male selection
trunk Legs male
male
buttons
Beauty programs display
buttons
Arms female
Female
selection
trunk Legs female
female
for each used channel; T-
MNPG05-08 Ed. 12/10/10 Pag. 34