General Safety Precautions; Use Precautions - DITEC Sector Reset Manuel D'installation, D'entretien Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USE INSTRUCTIONS

GENERAL SAFETY PRECAUTIONS

This user handbook is an integral and essential part of the product and must be delivered to the users.
Keep this document and pass it on to any future users.
This automation is a "vertical-roll door"; it must be used for the specific purpose for which it was
designed. Any other use is to be considered inappropriate and so dangerous. Assa Abloy Entrance
Systems AB declines all responsibility for damage caused by improper, incorrect or unreasonable use.
The device may be used by children over the age of 8 and by people with reduced physical, sensorial
or mental abilities, or lack of experience or knowledge, as long as they are properly supervised or
have been instructed in the safe use of the device and the relative hazards.
Cleaning and maintenance work must not be carried out by children unless they are supervised.

USE PRECAUTIONS

• Do not enter the door action area while the door is moving.
• In the event of a fault or malfunctioning, turn off the main switch. The operations of maintenance,
adjustment and repair must be carried out by skilled and authorised staff.
• Each automation has its own "Installation and Maintenance handbook", reporting the periodical
maintenance plan. Please take care to check all the safety devices.
BUTTONS
• Full opening: the door opens completely. The stroke can be fixed via the end stop microswitch.
• Partial opening: the door opens partially, to a point time-regulated by the RP trimmer.
• STOP: the door stops immediately.
• Closing: the door closes completely. The stroke can be fixed via the end stop microswitch.
MANUAL RELEASE LEVER (for emergency reopening).
Warning: before using the manual lever, turn the equipment off, putting the main switch on "0".
• When the lever is released, the brake is regularly working.
• Pulling the lever, the brake is unclamped.
To raise manually the panel, in case of power lacking or damage, act as follows:
• pull the release lever (fig. 2), releasing the brake;
• raise the panel on open door position;
• leave the lever back (fig. 3), in order to run the brake again.
Stop the opening of the panel before the safety edge hits the crosspiece.
TVA/BTW: BE 439,752,567 RCA/HRA 64232
Installer:
- 49 -
EN
Dynaco Europe n.v.
Waverstraat 21
B-9310 MOORSEL
Tel. (+32) 53 72 98 98
Fax (+32) 53 72 98 50
0DT848 01-12-2021

Publicité

Table des Matières
loading

Table des Matières