Electromagnetic Compatibility Information - Beurer FT 100 Mode D'emploi

Electromagnetic Compatibility Information

Table 1
For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer's declaration – electromagnetic emissions
The FT 100 is intended for use in the electromagnetic environment specified below.
The customer or the user of the FT 100 should assure that it is used in such an environment.
Emissions test
RF emissions CISPR 11
RF emissions CISPR 11
Harmonic emissions IEC 61000-3-2
Voltage fluctuations/flicker emissions
IEC 61000-3-3
Compliance Electromagnetic environment – guidance
Group 1 The FT 100 uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely
to cause any interference in nearby electronic equipment.
Class B The FT 100 is suitable for use in all establishments other
that domestic and those directly connected to the public
Not applicable
low-voltage power supply network that supplies buildings
used for domestic purposes.
Not applicable
226