Malfunction Table - Dibo SBH-G-D Mode D'emploi

MALFUNCTION
Machine does not start
No water pressure
Instable and to weak pressure
Water in product tank
No additions of products
No hot water SBH-D
No hot water SBJ-G
Aerator does not turn
SBH-D
SBH-G
Burner does not start
HP pump pulse

Malfunction table

At a possible malfunction one can consult the table mentioned below and if you
obtain on this basis no solution, we advise to contact a DiBO technician and/or
a recognized DiBO representative.
CAUSE
• Electrical supply not connected
• Net fuse defect
• Main switch on "0"
• Rest malfunctions
• To few water inlet
• Filter stuffed-up
• Air in water supply (leaks in water
supply)
• Nozzle or lance stuffed-up or worn-
out.
• Pressure regulator defect
• Rest malfunctions
• Non return valve in filter defect
• Suction pipe
• Suction filter stuffed-up
• Product tank empty
• Spray pressure to high
• Main switch not on position "2"
• Burner switch not on position "1"
• Heat resistors defective
• Temperature sensor defective
• Rest malfunctions
• Net fuse defect
• Main switch not on position "2"
• Burner switch not on position "1"
• Electrical motor defective
• No fuel
• rest malfunctions
• Leak or congestion in supply
conduit
• To much air present
DiBO 57
M A L F U N C T I O N TA B L E
SOLUTION
• Connect the electrical supply
• Check net fuse
• Put main switch on "1"
• Consult an expert
• Repair water inlet
• Clean/replace filter cartridge
• Put machine completely without
power! Repair leaks in supply.
• Clean or replace
• Consult an expert
• Consult an expert
• Replace suction filter
• Repair suction pipe
• Clean suction filter
• Refill or replace tank
• Lower spray pressure
• Put main switch on position "2"
• Put burner switch on position "1"
• Consult an expert
• Consult an expert
• Consult an expert
• Check net fuse
• Put main switch on position "2"
• Put burner switch on position "1"
• Consult an expert
• Refill fuel
• Consult an expert
• Clean/replace/repair
• De-aeration of cleaner
E N