3M DBI-SALA Mobi-Lok 2200094 Manuel D'instruction Pour L'utilisateur page 12

7.0 RFID TAG
7.1 LocATIoN: 3M product covered in these user instructions is equipped with a Radio Frequency Identification (RFID) Tag.
RFID Tags may be used in coordination with an RFID Tag Scanner for recording product inspection results. See Figure 12
for where your RFID Tag is located.
7.2 DISPoSAL: Prior to disposing of this product, remove the RFID Tag and dispose/recycle in accordance with local
regulations. For additional information on how to remove the RFID Tag, please refer to the website link below.
Do not dispose of your product as unsorted municipal waste. The crossed-out wheelie bin symbol indicates that
all EEE (Electrical and Electronic Equipment) must be disposed of according to local law through available return
and collection systems. Please contact your dealer or your local 3M representative for further information.
For more information, please visit our website: http://www.3M.com/FallProtection/RFID
8.0 LABELS
Figures 10 & 11 illustrate labels on the Vacuum Anchor. Figure 10 illustrates label location and placement for each
Vacuum Anchor model. Figure 11 illustrates the information present on each label.
Labels must be replaced if they are not fully legible. Information provided on the labels in Figure 11 is as follows:
Inspection Instructions (see Table 2)
A
Depress button to bypass alarm.
B
Compressed air or nitrogen: 80-150 psi (550-1035 kPa)
C
System Specifications (see Table 1): One user, 310 lb. (140 kg); Anchor Strength 2,700 lbf (12 kN) minimum; Materials
D
of Construction - Aluminum, Natural Rubber/Polybutadiene
Warning: Do not use secondary anchor pad unless this anchor pad is attached to working surface and vacuum gauge
E
indicates green.
Direction of secondary anchor pad
F
Warning: Manufacturer's instructions must be read and understood prior to use. All instructions must be followed.
G
Installation and use of this device must be supervised by a qualified person as part of a complete personal fall arrest
system.
Warning: All structural and system requirements must be met when using the Vacuum Anchor system.
H
Attaching the Vacuum Anchor
I
Releasing the Vacuum Anchor
J
This product is equipped with an RFID Tag.
K
Inspection Log
L
Secondary Anchor Pad: Device must be used in conjunction with a primary anchor pad. Do not connect compressed air to
M
the vacuum inlet on this anchor pad.
Direction of primary anchor pad and vacuum inlet
N
Aviation Rated
O
System Specifications (see Table 1): This apparatus is intrinsically safe and is suitable for use in Class 1, Division 1,
P
Group D T4 @ Ta = 115°F (46°C) max hazardous locations.
Warning: This device is not user repairable. To reduce the risk of ignition of a flammable or explosive atmosphere,
Q
batteries must be changed only in a location known to be non-hazardous. For replacement batteries, use only 3M part
number 9501987. To reduce the risk of explosion, do not mix old batteries with new batteries.
Connect to Secondary Anchor Pad
R
Vacuum Hose Attachment
S
T Read all instructions.
Applicable Standards
U
Maximum User Capacity of 1 person at 140 kg (310 lb.) combined weight or less.
V
Connect to Primary Anchor Pad
W
12