Reely Generation X Notice D'emploi page 68

Setting Rear Axle Camber:
For setting the camber, twist the threaded rod (A) of
the upper transverse link as for the front axle.
For this, turn out screw (B) from the rear. Then the
cross-linkage can be adjusted.
The damper bridge (C) and in the axle spur (D) have
several different suspension points for the upper
B
transverse link.
If the transverse link was attached in a different loca-
A
C
tion, this would change the camber when the wheel
deflects and extends.
D
The manufacturer has already selected the best set-
ting for the vehicle. Therefore, no changes should be
made by you.
Figure 10
68