Table des Matières
Publicité
MANTENIMIENTO
3-
ENTRETIEN
TO BE CARRIED OUT BY THE USER
BEFORE EACH START-UP
Engine and transmission
- ENGINE OIL: Check the level - Top up if
necessary
- DRIVE CHAIN: Check the tension – Adjust
if necessary
- COOLANT: Check the level – Top up if
necessary
Cycle
- BRAKE PADS: Check the wear – Renew if
necessary
- TYRES: Check condition and pressure
- BRAKES: Check the correct operation
- FUEL PIPES: Check for possible cracks
- Check for possible fluid leaks (petrol, oil,
coolant, brake fluid)
Electrical
- CONTROL ELEMENTS: Check the correct
operation
- LIGHTS: Check the operation of the
mechanisms and the correct functioning of
the bulbs/LEDs
- HORN: Check its correct operation
TO BE CARRIED OUT BY THE USER
AFTER EVERY WASHING
Engine and transmission
- DRIVE CHAIN: Clean and lubricate
Cycle
- BRAKE AND CLUTCH LEVERS: Lubricate
- BRAKES: Check the correct operation
136
Maintenance Lubrication Chart
Mod. 125
Electrical
- LOCKS AND LIGHT SWITCHES: Apply
anti-damp spray
EVERY 2 YEARS
Engine and transmission
- COOLANT: Change
Cycle
- BRAKE FLUID: Change
EVERY 500 km
Cycle
- DRIVE CHAIN: Clean and lubricate
Note 1
1ST SERVICE /RUNNING IN
Engine and transmission
- ENGINE OIL: Change (warm up the engine
before draining)
- OIL FILTER Change
- CARBURETTOR: Check tick-over opera-
tion and idling rpm – Clean and adjust if
necessary
Cycle
- WHEELS: Check the correct tension of the
spokes
General
- FINAL CHECK: Carry out an on-road test
drive, paying attention to the general ope-
ration of the brakes, steering, clutch, sus-
pensions, engine, lighting and instrument
panel lights
INSPECTION EVERY 6,000KM
Engine and transmission
- ENGINE OIL: Change (warm up the engine
before draining)
- OIL FILTER: Change
- AIR FILTER: Renew Note 1
- SPARK PLUG: Check the gap between the
electrodes – Adjust if necessary
- CARBURETTOR: Check tick-over opera-
tion and idling rpm – Clean and adjust if
necessary Note 1
- SECONDARY TRANSMISSION: Check
the chain tension – Adjust if necessary
Note 2
- SECONDARY TRANSMISSION: Check
the wear of the sprocket and plate Note 2
- SECONDARY TRANSMISSION: Check
the wear on the roller and chain guides –
Change if necessary
- COOLANT: Check the level – Top up if
necessary
Publicité
Table des Matières
