Arktic 235164 Mode D'emploi page 9

• Do not use water jet or steam cleaner for cleaning
and do not push the appliance under the water.
Putting the appliance out of reach for a long period of time
• Attention: Always unplug the appliance from the
electrical power outlet.
• Remove all the food and beverage inside the ap-
pliance.
Troubleshooting
If the appliance does not function properly, please
check the below table for the solution. If you are
Problems
The appliance does not
start cooling after connect
to electrical power supply.
The temperature is too
high or too low after con-
nect to electrical power
supply.
The appliance is leak of
water.
Too much noise.
All manuals and user guides at all-guides.com
Possible cause
Thermal cut-out activated.
The compressor is defective.
The power plug is connected cor-
rectly with the power supply out-
let.
The appliance is under strong
sunlight radiation or close to a
heat source.
The doors are not properly closed
or the sealing gasket is defective.
Too much food is placed inside the
appliance.
Surrounding ventilation is insuf-
ficient.
Too much ice on the evaporator.
Condenser blocked with dust.
The appliance is not properly lev-
elled.
The discharge outside is blocked.
Movement of water to the drain is
obstructed.
The water container is damaged.
The drip tray is over flowing.
The appliance is not placed hori-
zontally.
The appliance touches surround-
ing wall or other objects.
There are some loose parts inside
the appliance.
• No any parts can be cleaned in the dishwasher.
• Clean the appliance regularly.
• Clean the appliance as described in Cleaning. (See
== > Cleaning).
• Store the appliance in a cool, clean place and keep
out of reach of the children.
still unable to solve the problem, please contact the
supplier/service provider.
Possible solution
Contact with the supplier/service pro-
vider for repair.
Check the connection and make sure
all the connections are correctly con-
nected.
Move the appliance a new location to
avoid direct sunlight.
Close the doors properly.
Place less food inside the appliance.
Check that if sufficient ventilation is
provided by allowing at least 20cm
away from other objects or wall.
Defrost the appliance.
Contact with the supplier/service pro-
vider for repair.
Adjust the screw feet to level the ap-
pliance.
Clear the discharge outlet.
Clear the floor of the appliance.
Call your agent or qualified technician.
Contact with the supplier/service pro-
vider for repair.
Check to make sure the appliance is
placed horizontally.
Check to make sure that at least 20cm
away from other objects or wall.
Contact with the supplier/service pro-
vider for repair.
EN
9