Restore Default Settings; Ethernet Port Status Information - Cameo XNODE 8 Manuel D'utilisation

HARDWARE
The hardware revision.
MAC ADDRESSES
The MAC address of the node's Ethernet interfaces.
UIDS
The RDM UIDs (unique identifiers) of the eight output ports. These are numbers that unambiguously identify any RDM device. Since each
output port may act as an RDM controller, each output port has assigned its own RDM UID.

RESTORE DEFAULT SETTINGS

The default settings can be restored under Home > Menu > Restore Default Settings. In this menu, you will be asked whether you want to
continue restoring all settings. Push [OK] to confirm or [Cancel] to abort.
The default settings can also be restored from the Device Settings Page of the web interface.
This function will restore all settings to the defaults:
Name (Art-Net node 1 and 2): Cameo XNODE 8
 Short name (Art-Net node 1 and 2): XNODE 8
 Art-Net net (Art-Net node 1 and 2): 0
 Art-Net sub-net (Art-Net node 1 and 2): 0
 Art-Net RDM: Enabled on all output ports
 Independent universes: Disabled (available on firmware version 0.96 and older)
 Art-Net version: Art-Net 4 (available with firmware version 0.97 and newer only)
 All outputs enabled
 DMX output mode (all ports): Relaxed (firmware versions 0.95 and 0.96: Max. frame rate)
 Art-Net universe output 1-8: 0-7
 Failure behaviour (all outputs): Hold last look
 Merge mode (all outputs): HTP
 IP addresses: 2.X.Y.Z (primary Art-Net IP addresses)
 Netmask (both interfaces): 255.0.0.0
 Address display mode: Decimal
 LEDs: Unmuted
 Screen saver: Enabled
 User input locking: Disabled, password not set
 Web interface: Enabled (available with firmware version 1.00)

ETHERNET PORT STATUS INFORMATION

This screen is reached by pressing the Ethernet port button [E], which is located right next to the Ethernet port. See Device Overview on
page 6 for more precise information about the location of this button.
This screen shows the following information about the status of the Ethernet port on four lines:
 The first line below the title shows whether the link is up or down and what the current connection speed is (10 Mb/s or 100 Mb/s).
 The next line informs whether the link is full or half duplex if a link is established.
 The last two lines display the currently configured IP address and the currently configured netmask.
When the Art-Net version is set to Art-Net 3 or if the firmware is version 0.96 or lower, the node has two virtual interfaces. Use the encoder knob
or push the Ethernet port button [E] again to change for which of the two virtual interfaces the IP address and the netmask is displayed.
While the information on the first two lines concerns the physical Ethernet interface, the IP address and the netmask may differ between the
two virtual interfaces of the XNODE 8.
20
1
• For firmware versions 0.99 and earlier, RDM enabled per default.
1