System Settings (Settings) - Cameo MOVO BEAM 200 Manuel D'utilisation

STANDALONE OPERATION (SCENES)
Similar to when using a DMX control unit, the standalone operating mode Scenes makes it
possible to set pan, tilt, dimmer, RGBW, LED ring etc. directly on the device with values from 000
to 255. A total of 8 individual scenes (Scene 1–8) can be created, edited, saved and recalled. It is
also possible to record scenes via DMX controller (Record Scene) and transfer scenes completely
to a slave unit (Copy to Slave).
Starting from the main display, press the rotary-push encoder to enter the main menu (MENU).
Select the menu item Control by turning and pressing the encoder. Turn the encoder to select the
menu item Scenes and press the encoder again to confirm.
This will take you to the submenu for setting the submenu items. See table (rotate the encoder to
select and push the encoder to confirm selection, change value or status by rotating, confirm by
pressing encoder, go back with <=):

SYSTEM SETTINGS (SETTINGS)

Starting from the main display, press the rotary-push encoder to enter the main menu (MENU).
Turn the encoder to select the system Settings menu and press the encoder.
This will take you to the submenu for configuring the submenu items, see table:
15