Slave Mode; Advanced Settings - Cameo 4 HEAD MOVING BAR HYDRABEAM 4000 Manuel D'utilisation

ACTIVATE SOUND CONTROL
Select one of the auto programmes as described above under CONFIGURE AUTO MODE. Now select the menu item "Sound Mode" (shaded
in colour) using UP and DOWN, confirm with ENTER, then use UP and DOWN again to select "On" and confirm with ENTER. You can set
the microphone sensitivity by selecting the menu item "Sound Sens" using the UP and DOWN buttons, confirming with ENTER and then
using UP and DOWN once again to select a value between 00 and 99 (hold button down to change values quickly, 00 = minimum and 99
= maximum sensitivity). Confirm with ENTER and press MENU twice to return to the main display. After approx. one minute of no input, the
main display is automatically activated and the selected sound programme is shown clearly at the centre of the display. Now the spotlight is
controlled via the built-in microphone and follows the beat of the music (bass impulses).

SLAVE MODE

Press MENU to access the selection menu for system settings. Select the menu item "Slave Mode" (shaded in colour) using UP and DOWN,
and confirm with ENTER. Press MENU to return to the main display. After approx. one minute of no input, the main display is automatically
activated and SLAVE is shown clearly at the centre of the display. Connect the slave and the master units (same model) with a DMX cable,
and enable one of the standalone modes on the master unit (Auto, Sound). The slave unit will now follow the master unit.

ADVANCED SETTINGS

Press MENU to access the selection menu for system settings. Select the menu item "Advanced Settings" (shaded in colour) using UP and
DOWN, and confirm with ENTER. This will take you to the sub-menu for configuring the following sub-menu items (selecting using UP and
DOWN, confirm with ENTER):
7