Slave Mode; Sound Control Mode - Cameo PAR 64 CAN Manuel D'utilisation

mODE SELECTION:
AUTO RUNNING mODE
Press the mode button to select Auto mode. The unit will then run automatically through all of the built-in pro-
grammes. The run speed can be pre-set via the speed of the colour change and colour fade modes.
.

SLAVE mODE

Press the MODE button to enter SLAVE MODE.
Link the slave unit and the master unit via DMX
cable. The slave unit will follow in sequence with
the master unit
LED ON/OFF mODE
Press the MODE button to enter the LED ON/OFF mode (repeatedly if necessary). Then press enter to set LED
display to ON or OFF by using the UP and DOWN buttons. In ON mode the LED display will be on permanently.
In OFF mode the LED display will be switched off automatically after 5 seconds. It will be turned on again by
pressing any of the four buttons.

SOUND CONTROL mODE

Press the mode button to select Sound Control Mode. The unit will then
run thanks to the built in microphone. Press ENTER (3. and 4. digit blink)
again to adjust microphone sensitivity (00-99) by using UP and DOWN
buttons.
DmX ADDRESS SETTING mODE
Press the MODE button to enter DMX ADDRESS SETTING MODE.
Press ENTER to access edit mode (the last 3 figures will blink). Use the
UP and DOWN buttons to set the DMX address (A001 - A512).
Press ENTER to confirm.
10