Slave Mode - Cameo H2 FC Manuel D'utilisation

TIMER FUNCTION (Timer)
The timer function allows the standalone modes Static, Color Macro and Tuneable White to be timer controlled in such a way that the Fade
In time can be configured from 0.5 seconds to 24 minutes, the Dwell Time from 0.5 seconds to 24 hours and infinite (Limitless) and the
Fade Out time from 0.5 seconds to 24 hours.
After activation of the timer function, the timer control will be implemented upon the next system start.
Starting from the main display, press MENU to enter the main menu. Now use the controls UP and DOWN to select the menu item Stand
Alone and confirm with ENTER. Again use UP and DOWN to select Timer and confirm with ENTER. Under point Switch, select On and
confirm again with ENTER. For the individual timer control settings, select Fade In, Dwell Time or Fade Out and confirm with ENTER. You
can now use UP and DOWN to configure the desired setting. Confirm all entries with ENTER. To deactivate the timer function, under point
Switch, select the setting Off and confirm with ENTER. Please note: The timer function is suitable for use in master/slave mode via cable.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info

SLAVE MODE

Starting from the main display, press MENU to enter the main menu. Using UP and DOWN, select the menu item Slave and confirm with
ENTER. Connect the slave and the master units (same model, same software version) using a DMX cable, and enable one of the standalone
modes on the master unit (Auto, Static, Color Macro, Tuneable White) and if required, the timer function. The slave unit will now follow the
master unit.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
SYSTEM SETTINGS (Settings)
Starting from the main display, press MENU to enter the main menu. Using UP and DOWN, select the menu item Settings and confirm with ENTER.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
This will take you to the submenu for setting the submenu items (see table, select with UP and DOWN, confirm with ENTER, change value or
status with UP and DOWN, confirm with ENTER).
Settings
Display Reverse = Rotate display
Display Back- = Display lighting
light
DMX Fail = Operating status with DMX
signal fault
Stand Alone
Auto Switch
Static Fade in
Dwell Time
Color Macro
Tuneable White Fade out
Edit User Color
Timer
Mode
Slave
On
Off
On
Off
Hold
Blackout
White
Timer
On / Off
0.5s-24h
0.5s-∞h
0.5s-24h
Display is rotated by 180° (e.g. for overhead installation)
No rotation of the display
Permanently on
Deactivation after approximately 1 minute of inactivity
Last command is retained
Activates blackout
All LEDs 100% output
11