W-Dmx™ Status - Cameo H2 FC Manuel D'utilisation

MAIN DISPLAY 1 SLAVE MODE
The display shows Mode Slave.
Mode
Slave
MAIN DISPLAY 2 W-DMX STATUS
The display shows the W-DMX status. Switch between both main displays by briefly pressing ENTER and DOWN at the same time.
Fixture Status
W-DMX™
To pair the W-DMX receiver with a W-DMX compatible transmitter, W-DMX must be activated (W-DMX On) in the receiver's menu under
Wireless Settings. The Reset command must be also executed under the same menu item (select Reset and confirm with ENTER). The
receiver is now in pairing standby and waiting for a pairing request from a transmitter. Start the pairing by selecting Link in the menu of the
transmitter and then confirm; the pairing now takes place automatically. In the same way, several receivers can be paired to a transmitter
either simultaneously or one after the other. A W-DMX connection is always maintained until the connection is disconnected by means of the
Reset command in the receiver or the Unlink command in the transmitter, regardless of whether a device has been disconnected from the
power supply in the meantime.
W-DMX™ STATUS
W-DMX W-DMX
deactivated activated,
not paired
CONFIGURE DMX START ADDRESS
Press MENU to access the main menu. Now use the controls UP and DOWN to select the menu item
DMX address and confirm with ENTER. You can now configure the DMX start address with UP and DOWN (highest value dependent on the
activated DMX mode). Confirm by pressing ENTER.
Menu
DMX Address
DMX Mode
DMX Delay
Stand Alone
Slave
Settings
System Info
W-DMX W-DMX
activated activated
and and
paired, paired,
Transmitter no DMX-Signal
switched off DMX signal is present
or out of
range
DMX Address
001 - 512
RF SIGNAL STRENGTH
W-DMX
activated
and
paired,
7