W-Dmx; W-Dmx™ Status - Cameo CLOXW Manuel D'utilisation

IP Address 192.168.000.150
Subnet Mask 255.255.255.000
030°C Fan Auto
MAIN DISPLAY SLAVE AND STATIC MODE
The top line of the display shows whether a control signal is available on the device and the middle field shows the SLAVE or STATIC mode
with the selected scene (Run Scene x). The bottom line displays the temperature of the LED unit, the fan mode and W-DMX status. If the
control signal is interrupted in slave mode, the characters in the display start flashing and "None" is shown after "Controlled by" in the top
line (no signal); when the control signal is available again, the flashing stops.
Control signal display
Tap -> main menu
Operating mode
Temperature of the LED unit
------------------- Menu ------------------
Control
Settings

W-DMX™

Info
To pair a W-DMX receiver with a W-DMX compatible transmitter, the Reset command must be executed in the menu item WDMX under
Receiver (select Reset and confirm). The receiver is now in pairing standby and waiting for a pairing request from a transmitter. Start the
Service
pairing by selecting Link in the menu of the transmitter and confirming; the pairing now takes place automatically. In the same way, several
receivers can be paired simultaneously or one after the other to a transmitter (e.g. for master / slave operation). A W-DMX connection is
Quicklight
always maintained until the connection is disconnected by means of the Reset command in the receiver or the Unlink command in the
Help transmitter, regardless of whether a device has been disconnected from the power supply in the meantime.
W-DMX™ STATUS
------------------- Menu ------------------
Control
Settings
W-DMX W-DMX
Info
deactivated as receiver
activated,
Service
not paired
Quicklight
Help
The following is a description of how to operate the spotlight using the rotary-push encoder and the BACK button next to the display.
10
Controlled by Master
SLAVE
030°C Fan Auto
Fan mode
------------------- Menu ------------------
Control
Settings
Info
Service
Quicklight
Help
------------------- Menu ------------------
Control
Settings
W-DMX W-DMX
Info
as receiver as receiver as receiver
activated activated
Service
and
and
Quicklight
paired, paired,
Transmitter no DMX signal
Help
switched off DMX signal is present
or out of
range
!
A warning triangle is displayed in
(None)
the event of malfunction. Tap for
further information
W-DMX status
W-DMX W-DMX W-DMX
as trans- as trans-
activated mitter
and with G3 with G4s
paired, standard standard
activated, activated,
DMX signal DMX signal
is present is present
W-DMX W-DMX
as trans- as trans-
mitter mitter
with G3 with G4s
standard standard
activated, activated,
no
DMX signal DMX signal
mitter
no