Dmx Address; Dmx Mode - Cameo ZENIT P100 DTW Manuel D'utilisation

Operation
= Operation mode
Mode
PWM Fre-
= LED PWM Frequency
quency
Automatically locks the
Autolock =
control elements
Calibra- Calibration of warm white
=
tion and amber
Factory
= Reset to factory settings
Reset
Dimmer curves
Linear
DMX value
DEVICE INFORMATION (System Information)
You can access the options menu by pressing MODE. Using the UP and DOWN control keys, now select the "System Information" menu
option (note arrow) and confirm with ENTER.
---------- Menu ---------

DMX Address

DMX Mode

Stand Alone
Slave
Settings
System Information
This will take you to the submenu for displaying the device information (select using UP and DOWN, show information by pressing ENTER):
System Info
Firmware = Displays the device firmware
Displays temperature of
Temperature =
LED unit
Time Info = Displays operating time
10
Blinder
Normal
Silent
800 Hz / 1200 Hz /
2000 Hz /
3600 Hz / 12 kHz /
25 kHz
On
Off
Warm white
Amber
Reset?
Exponential Logarithmic
DMX value
DMX value
Main CPU
LED
Celsius/
Fahrenheit
Total:
Current
Last:
The blinder mode allows brief maximum brightness
Normal operation (automatic fan control)
Extra quiet operation with reduced brightness, if required
Sets the LED PWM frequency
Automatically locks the control element after approx. 30
seconds of inactivity. Display shows: "LOCKED"
Unlock: Press UP and DOWN at the same time for approx. 5
seconds
Deactivates automatic locking of the control elements
Individual calibration. Cross-mode configuration, with values
from 000–255
Reset to factory settings:
Confirm with ENTER, cancel with MODE
S-curve
DMX value
Vx.xx
LED TEMP xxxC / xxxF
Unit Celsius (= displays in degrees Celsius)
Unit Fahrenheit (= displays in degrees Fahrenheit)
Displays the total operating time in hours and minutes
Displays the current operating time in hours and minutes
Displays the last operating time in hours and minutes