Oled Display - Cameo ZENIT P100 DTW Manuel D'utilisation

5

OLED DISPLAY

Displays the current operating mode and other system settings.
6 TOUCH-SENSITIVE CONTROLS WITH BACKLIGHTING
MODE
You can access the options menu by pressing MODE. Pressing it again will return you to the main screen. If you press MODE without having
first pressed ENTER to confirm a value or status change, the previously confirmed value or status shall be restored.
ENTER
Pressing ENTER takes you to the menu level, on which value changes can be made, and you can reach the submenu using ENTER. Value or
status adjustments can also by confirmed by pressing ENTER.
UP and DOWN
Selects the individual menu options in the selection menu (DMX address, operating mode, etc.) and in the submenus. Allows you to change
the value of a menu option, such as the DMX address, as desired.
7 PRESSURE EQUALIZATION ELEMENT
Pressure equalization element to avoid the buildup of condensation within the housing. Protect this element from contamination in order to
ensure that it functions properly.
8 SAFETY EYEBOLT
When installing in an overhead location, secure the device using a suitable safety cable on the safety eyebolt.
9
HOUSING FAN
The IP65 housing fan is located in the cooling unit between the controller unit and the unit with LED, zoom, and lens. Do not cover the machine,
and keep the ventilation slats free of contaminants in order to ensure that the fan functions properly and air can circulate freely.
NOTE: In order to ensure that the DMX sockets are protected from spray water in accordance with the IP65 protection class, the special
DMX input and output sockets must be correctly sealed with the special IP65 XLR plugs, or capped with the rubber sealing cap. When
connected correctly, the POWER IN and POWER OUT sockets will protect against spray water in accordance with IP65, as will the rubber
sealing cap.
6
9