Connections, Operating And Display Elements; Oled-Display; Control Buttons - Cameo AZOR B1 Manuel D'utilisation

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

4
1
POWER IN
powerCON-compatible mains input socket. Operating voltage 100-240 V AC/50-60Hz. Connection via the supplied mains coble.
2 POWER OUT
powerCON-compatible mains output socket for power supply to additional CAMEO spotlights. Ensure that the total current consumption of
all connected devices does not exceed the value specified on the device in amperes (A).
3 FUSE
Fuse holder for 5 x 20mm micro fuses. IMPORTANT: Replace the fuse only with a fuse of the same type and value. In the event of repeated
fuse failure, please contact an authorised service centre.
4
DMX IN
Male 3-pin and 5-pin XLR sockets for connection to a DMX control device (e.g. DMX console).
5 DMX OUT
Female 3-pin or 5-pin XLR sockets for sending the DMX control signal.
6

OLED-DISPLAY

The OLED display shows the currently activated mode (main display), the menu items in the selection menu and the numerical value or
operating mode in certain menu items. If there is no input for approx. 30 seconds, the display automatically returns to the main display. If
there is no control signal at the DMX input, the characters in the display will flash (DMX and slave operation).
7

CONTROL BUTTONS

MENU – Press MENU to access the selection menu. Press again to return to the main display.
UP and DOWN – Select the individual menu items in the selection menu (DMX address, mode, etc.) and in the sub-menus and change the
value of a menu item, such as the DMX address.
ENTER – In the selection menu, press ENTER to access the menu level in which values can be changed. Confirm value changes by pressing
ENTER.
5 4
6
3
5
1
7
2
5