Connections, Operating And Display Elements - Cameo NANOROLL 200 Manuel D'utilisation

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

1
1 POWER IN
IEC mains socket with built-in fuse holder. A suitable power cable is included.
IMPORTANT: Replace the fuse only with a fuse of the same type and of the same value according to the stamp on the device! In the event
of repeated fuse failure, please contact an authorised service centre.
2
POWER OUT
IEC power output socket. Facilitates power supply to other CAMEO lights. Ensure that the total current consumption of all connected devices
does not exceed the value specified on the device in amperes (A).
3
DMX IN
Male 3-pin XLR socket for connection to a DMX control device (e.g. DMX console).
4
DMX OUT
Female 3-pin XLR socket for sending the DMX control signal.
5
LED DISPLAY
The four-digit LED display shows the operating mode and other system information.
6
CONTROL BUTTONS
MODE: Selection of the main menu items. Move up one level in the menu structure.
ENTER: Confirm programme selection and value changes.
UP and DOWN: Selection of operation mode , system settings and programmes, e.g. changing of programme speed and DMX address.
7
MIC
Microphone for music-control mode
8
SECURING LUG
Eyelet for safety rope. Overhead installation must only be carried out by qualified personnel. The spotlight must be fitted with a suitable
safety rope to ensure that it does not fall down.
8
5
2
6
7
3 4
5