Technical Data - Cameo NANOROLL 200 Manuel D'utilisation

Pin Assignment
DMX cable with 3-pin XLR connectors:
Shield
1
3
2
DMX TERMINATORS (TERMINATING RESISTORS)
To prevent system errors, the last device in a DMX chain needs to be equipped with a terminating resistor (120 ohm, 1/4 Watt).
3-pin XLR connector with a terminating resistor: K3DMXT3
5-pin XLR connector with a terminating resistor: K3DMXT5
Pin Assignment
3-pin XLR connector:
1
3
2
DMX ADAPTER
The combination of DMX devices with 3-pin connectors and DMX devices with 5-pin connectors in a DMX chain is possible with suitable
adapters.
Pin Assignment
DMX Adapter 5-pin XLR male to 3-pin XLR female: K3DGF0020
Pins 4 and 5 are not used.
Pin Assignment
DMX Adapter 3-pin XLR male to 5-pin XLR female: K3DHM0020
Pins 4 and 5 are not used.

TECHNICAL DATA

Model number:
Product type:
Type:
Colour spectrum:
Number of LEDs:
LED type:
Beam angle:
DMX input:
DMX output:
Protocols:
DMX mode:
DMX Functions:
PAN movement:
TILT movement:
Flash rate strobe:
Standalone modes:
Controls:
Indicators:
Operating voltage:
Power consumption:
Fuse:
Power input:
1
3
2
CLNROLL200
LED moving lights
LED scanners
RGBW
2
10 W
4°
XLR 3-pin male
XLR 3-pin female
USITT DMX-512
2-channel, 4-channel, 11-channel, 16-channel, 19-channel
strobe, dimmer, auto-programs, TILT, PAN, programme speed, sensitivity, sound-control
180°
unlimited barrel rotation
1 – 20Hz
auto programmes, sound-control, Master/Slave mode
Mode, Enter, Value Up, Value Down
LED display
100 V AC - 240 V AC, 50 - 60 Hz
40W
F3AL 250 V
IEC power connector male
DMX cable with 5-pin XLR connectors (pin 4 and 5 are not used):
5
4
3 3
2
1
Shield
5-pin XLR connector:
5
4
3
2
1
5
4
2
1
9