Connections, Control And Display Elements; Oled Display - Cameo ZENIT Z180 G2 Manuel D'utilisation

The spotlights comply with the RDM standard (Remote Device Management). This device manager allows the user to request the status of
and configure RDM end devices via an RDM-capable controller.

CONNECTIONS, CONTROL AND DISPLAY ELEMENTS

1
POWER IN
1
IP65 Power Twist power input connector with rubber sealing cap. Operating voltage: 100 - 240V AC / 50 - 60Hz. Connect using the provided
power cable (when not in use, always close with rubber sealing cap).
2 POWER OUT
IP65 Power Twist power output connector with rubber sealing cap. Serves to provide power to additional CAMEO spotlights. Ensure that the
total power consumption of all devices connected to the device does not exceeded the given Ampere (A) value (when not in use, always
close with rubber sealing cap).
DMX IN
3
Male IP65 5-pin XLR connector to connect a DMX controller (e.g. DMX console, when not in use, always close with rubber sealing cap).
DMX OUT
4
Female IP65 5-pin XLR connector to transmit a DMX controller signal (when not in use, always close with rubber sealing cap).
5

OLED DISPLAY

Displays the current operating mode and other system settings.
5
6
2 3
8
44
7
5